KAEDAH MEMATERI

1. Before the weld
   
   
   1. Prepare materials and soldering equipment on the table work. 
   2. Clean the end of the bit of paper pemateri las.
   3. Place the tool on the parking pemateri pemateri tool.
   4. Heat pemateri tool.
   5. Celupkan pemateri bit in the end the flux container.
   6. Sentuhkan end a little bit of tin pemateri pemateri.
   7. Make sure that bode circuit components and feet clean and free from oxide layers.
2. During the solder
1. Pemateri tilt to 30 degrees.
2. Make sure the wires are on the outside of your hand.
3. Sentuhkan pemateri the foot end of the bit parts.
4. Sentuhkan pemateri of the leg without lifting components pemateri tool bit. 
5. When the tin melts well, keep the tip of pemateri bit of tin solder and components of leg.

1. After solder
   
   1. When finished, clean the bit of the shine bit damp sponge.
   2. If it appears there is an excess of tin solder, dilute with pemateri end and pick up by using solder sucker.
   3. Toe the finished component may be removed by dipateri playar side cutters.
   4. Clean and store all tools.
   5. Store tools in pemateri reserved.
   6. Proper soldering to avoid short circuit.